Jim:
I personally would consider Davis Bury Flex (9914) for the whole project.
I've used a LOT of this cable and just love it. It is very easy to work with
and has similar loss characteristics to LMR400.
73, Jamie
WB4YDL
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Jim Miller
Sent: Friday, February 26, 2010 6:11 PM
To: TowerTalk@contesting.com
Subject: [TowerTalk] Frequent crankup coax recommendation
I've got a 30ft three section crankup (AB1342) that I'll be putting up
this spring. It will likely be cranked up and down nightly with a
hexbeam on top. I was thinking of RG8x for its flexibility for the
20ft resulting loop and RG213 for the run to the mast and the first
10ft.
I was wondering if LMR400 (DB version since it will need to be buried
for most of the distance) might be a better choice. I was worried
about a large diameter coax in such a loop but upon reading the 1"
minimum bend radius for LMR400 I'm thinking it may be a good choice
afterall.
I've never seen any LMR400 except in web pics and a datasheet so I'd
appreciate some advice from actual users.
thanks
jim miller, ab3cv
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
E-mail message checked by Spyware Doctor (7.0.0.514)
Database version: 6.14450
http://www.pctools.com/en/spyware-doctor-antivirus/
E-mail message checked by Spyware Doctor (7.0.0.514)
Database version: 6.14450
http://www.pctools.com/en/spyware-doctor-antivirus/
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|