John, I think you'll fnd that most people using the receive jack are using
some type of outboard receive antenna switch to take the receiver out of
harms way. I have damaged the receive section by not using the correct
switching.
73 Bill K3SV
----- Original Message -----
From: <jcowens1@comcast.net>
To: "Towertalk" <towertalk@contesting.com>
Sent: Wednesday, January 13, 2010 1:50 PM
Subject: [TowerTalk] FT1000MP
>
>
> Would like to get in touch with anyone who did own or does own a FT1000MP
> and has used the separate receive antenna jack for a receive only antenna
> while using the A or B antenna jacks for the transmit antenna. The manual
> does not say if it blanks the receive antenna input when transmitting.
> This could cause a problem with RF coming into the receive jack when
> transmitting on A or B on the same band. Anyone operating Top Band and
> using separate Rx and Tx antennas would likely have done this.
>
>
>
> John Owens - N7TK
>
>
>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|