Towertalk
[Top] [All Lists]

Re: [TowerTalk] Gin pole

To: <k2owr@comcast.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Gin pole
From: Tek Supp <teksaport@hotmail.com>
Date: Thu, 17 Dec 2009 15:30:01 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I bought my pullies (bottom and top) and the clamps from this guy and although 
they are home made, they work fine so far - I've used them about 5 times and 
I'm pleased, but I reserve to the right to complain in the future   ;-).  But 
for the tubing I went to a local shop called "Affiliated Metals" (801) 
363-1711.  A 20' 6061 T6 (2" OD x .125W 1.750 ID x 240") with tax was 48.08 
this summer.  It's in SLC, UT and I have no idea about shipping.  But perhaps 
you can call them and find out.  I then cut it down to 14' so I could have 
enough spacing/supported area for the tower clamps to the gin pole, but I 
didn't feel I needed the full 20'.  I can't say that this helped you, but it's 
at least another avenue to pursue.

 

Also suggested by w9iix, I also decide to buy a 20' of 1/4 wall for heavier 
pulls.  I haven't used it yet, but it was a lot more (and I can't find my 
invoice right now for the pricing).  The .125 (1/8") wall can flex, so be aware 
of that if you are lifting anything heavy.  I was dismantling a 25G top section 
with rotor and mast and it flexed/bent toward the load a good foot.  But I can 
state that the 20' 1/4" wall is quite a bit heavier and you don't want to be 
playing around with it up on the tower much.

 

Thanks

John

K7ALA

 

 


 
> From: k2owr@comcast.net
> To: towertalk@contesting.com
> Date: Thu, 17 Dec 2009 16:34:03 -0500
> Subject: [TowerTalk] Gin pole
> 
> :::: Anyone know where I can get a suitable 2" OD .125 wall 6061 piece of 
> aluminum tubing, 12' long to use for a gin pole?
> It needs to be within 100 miles of Knoxville TN so I can pick it up. 
> I'm aware that w9iix.com sells one in two pieces so it can be shipped, but 
> then he asks a ridiculous $200 for it, plus shipping.
> I already know this can be had at various tubing supply places for about $65, 
> but they want $125 to ship it anywhere.
> 
> Any suggestions appreciated.
> 
> BILL K2OWR
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
                                          
_________________________________________________________________
Hotmail: Trusted email with powerful SPAM protection.
http://clk.atdmt.com/GBL/go/177141665/direct/01/
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>