Sounds like the upper switch is stuck closed, did you check its operation
with a meter?
Mike, K6BR
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Larry Essary
I have just about finished my re-furbishing and installation of my LM-470
tower.
I was working with the motor today. The tower goes up and down and the
lower limit switch works
but the upper limit switch does not. The tower keeps going up once it trips
the upper switch.
If I remove the upper limit switch cable from the controller the tower will
not go up at all.
My assumption is that the upper limit switch is working properly and the
problem is in the controller.
Anyone have any ideas on this problem ?
Also... are the motors on these towers VERY noisy ? Mine makes a LOT of
noise.
tnx,
Larry K5XG
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.423 / Virus Database: 270.14.43/2474 - Release Date: 11/01/09
07:38:00
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|