Mike,
I handle a lot of credit card machine and ask my paper supplier about
these. He (www.mypaperrolls.com) says he does not have it but
suggests that you take a look at the following link
http://www.pospaper.com/thermal-2-80-zebra-36rolls.html
He says the sprocket holes are probably not required and most thermal
printers rely on friction feed anyway. The price is for 36 rolls.
However, you may want to contact POS Paper and ask them for a sample
to make sure it will fit your equipment - most of these vendors are
good about making sure the paper will fit your equipment..
Good luck - hope this helps you.
73's
Tom, N4NW
At 01:04 AM 9/28/2009, Mike Wetzel wrote:
>Anyone know where to get reasonably priced chart paper (thermal type) for a
>Tektronix 1502 TDR? I did a search and see a note where cost is $36/roll!!!
>A little crazy. It is 2" wide with sprocket holes on one side that are
>approximately .0197" apart (slightly over 5 holes per 1").
>
>
>
>Only looking for a couple rolls.
>
>
>
>Thanks,
>
>
>
>Mike W9RE
>
>
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
Tom Gregory, N4NW
n4nw@n4nw.org
N4NW LLC - Complete Merchant Services
Check out local N4NW weather conditions real-time -->> http://www.n4nw.org
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|