Thanks David,
I got some great info from Dwight NS9I, pictures, manuals and the works!
I have that large base pole and will further enhance the installation
by guying the top of the 1st section. I intend to use the 60' EZ-Way
for a 10m long boom 5 el yagi -- yes, I know not much ten not but
then the tower is not up yet!
Thank you for your feedback.
73's Tom
At 05:27 PM 9/24/2009, David Thompson wrote:
>Tom,
>
>I think EZ-Way had a guy bracket sort of like the Rohn 25 and
>45. As I recall the RBX-60 was self supporting with the big bottom
>anchor up to say 10 SQ FEET. I have a Tristao that is usually self
>supporting but Lou welded guy rings on the top of each
>section. This could be a possibility.
>73 Dave K4JRB
>----- Original Message ----- From: "N4NW" <n4nw@n4nw.org>
>To: <towertalk@contesting.com>
>Sent: Thursday, September 24, 2009 9:22 AM
>Subject: [TowerTalk] EZ-WAY RBX/CRX 60-3 tower manual needed
>
>
>>
>>>I have a EZ-Way 60' three section tower - looks to be the RBX-60-3.
>>>I have found some information from manuals on the Internet. I am
>>>seeking the pages with the parts list, parts specifications (length
>>>of cables) etc. All manuals I have do NOT have this information.
>>
>>The old EZ-Way brochure mentions use of guys on all their towers but
>>I can find no reference as to how guys would be attached if anyone
>>has information on this I would appreciate your input.
>>
>>The EZ-Way I have is in excellent condx but I still desire to replace
>>the lift cable, tilt cable and lift winch.
>>
>>Thanks & 73's
>>Tom
>>
>>_______________________________________________
>>
>>
>>
>>_______________________________________________
>>TowerTalk mailing list
>>TowerTalk@contesting.com
>>http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|