Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rohn 25G Accessory Shelf

To: "Larry Boekeloo" <lboekeloo@sbcglobal.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Rohn 25G Accessory Shelf
From: "Dave Johnson" <djohnson@windstream.net>
Date: Sat, 19 Sep 2009 15:43:07 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Hey Larry,

I know this doesn't answer your question but if you are going to put a rotor 
on that plate, have you thought about how you will get the rotor out when it 
goes bad?

Dave - K4SSU



----- Original Message ----- 
From: "Larry Boekeloo" <lboekeloo@sbcglobal.net>
To: <towertalk@contesting.com>
Sent: Friday, September 18, 2009 7:32 PM
Subject: [TowerTalk] Rohn 25G Accessory Shelf


Ok, dumb question time.....

I want to put an accessory shelf mid-way in a section of Rohn 25G. I can 
easily add it between the sections but not in the middle. Is that possible 
or is there a special shelf to do that? This is taking longer than erecting 
the tower.....

Thanks.

Larry, KN8N
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>