Hi Frank,
I don't know which holes I used on my C3SS that is at 42'. But here are the
SWR measurements with 200' of Buryflex:
10M
28.0 - 1.2
28.1 - 1.11
28.2 - 1.11
28.3 - 1.11
28.4 - 1.16
28.5 - 1.26
28.6 - 1.4
15M
21.0 - 1.27
21.1 - 1.17
21.2 - 1.09
21.3 - 1.12
21.4 - 1.19
20M
14.0 - 1.36
14.1 - 1.13
14.2 - 1.09
14.3 - 1.33
It sure seems very broad. Maybe too broad?
73,
N2TK, Tony
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of VO1HP
Sent: Thursday, September 10, 2009 11:32 AM
To: towertalk@contesting.com
Subject: [TowerTalk] C3SS element holes
I am reassembling a C3SS getting it ready for installation on my 52 ft
tower.
The previous owner riveted the driven elements so that there are no visible
rivet holes so I am taking this to mean the driven elements are set for SSB
portions of the bands. I operate almost exclusively CW & Digital modes.
I need some field experience from current users on the element settings
for the lower portions of the bands. I'd like the SWR to be lowest around
14.050 ; 21.100 ; 28.100 etc or thereabouts.
What has been the experince with this antenna and the general SWR curves
that I can expect to see with the antenna at 52 ft?
73 Frank VO1HP
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|