This has worked well for me.
http://www.l-com.com/item.aspx?id=3896
Standard disclaimer
73,
Joe kk0sd
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of David McKenzie
Sent: Tuesday, June 30, 2009 9:39 AM
To: Jim Hoge; towertalk@contesting.com
Subject: Re: [TowerTalk] crimping tools
Jim, I'm using the RF Industries crimp tool that I got on ebay with both
sets of interchangeable dies for crimping cables from RG59 through LMR400
and am very happy with it. Mainly I am using it to crimp LMR-240 but I have
the LMR400 connectors for my bury-flex coax as well and have had no issues.
It is a ratchet-type crimper and appears to be heavy duty. I've crimped
maybe 20 connectors to this point with no problems whatsoever. I don't know
what the tool retails for but I got it for about $75 on ebay, and the crimp
connectors are anywhere from $1.90-$3.50 each depending where you get them.
Certianly beats soldering any day of the week in my opinion.
Regards,
David KB1FSY
On Mon, Jun 29, 2009 at 12:44 PM, Jim Hoge <knowkode@sbcglobal.net> wrote:
> I am seeking opinions on crimping tools for LMR-400 coax. How well do the
> standard crimpers, both fixed die and interchangable die units perform
with
> this cable? Is a piston type crimper worth the extra investment if I won't
> be doing cable larger than 400?
>
> tnx,
> Jim W5QM
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|