Darl,
Easy to replace - just remove top cover
It uses a type 1819 and if U neber want to have to replace the bulbs again
this advice from K6EL in a previous post
He wrote:
You may want to replace it with a direct replacement LED.
I just was alerted to this web page and it is awesome! I ordered a
couple for the box to check them out and they are very high quality. No
minimum order and very quick service.
https://www.superbrightleds.com/led_prods.htm
73, Dennis N6KI
On Fri, Jun 12, 2009 at 6:42 AM, Darl Deeds <ddeeds@thewavz.com> wrote:
> Hi all. I have a Ham IV rotor from Hygain. I have the version that has two
> bulbs in the control box. Both bulbs have blown. I see nothing in the manual
> about changing them and in looking at them it looks like a total pain to
> change them. Are there any suggestions for an alternative or a good way to
> change them. Thanks in advance.
>
> Darl NA8W
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|