K7LXC@aol.com wrote:>
> Do you need it because of over-galvanizing? I just use a round
> file to get the rough edges off. Works fine.
>
> Cheers,
> Steve K7LXC
> TOWER TECH
>
no, some of these ends are so mis shapen that I cannot get a male onto
a female... so a mandrel to drive into the female to reset its
"roundness" and a suitable tool for the male to get it so that it will
slip fit into the male. of course, you simply have to number these
sections AFTER try fitting them together on the ground.
thanks chas
k5dam
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|