Hello All,
I sent the post below to the "antennaware" section of our group list. Someone
suggested that i send it to you kind folks in the event there are more ideas
and suggestion to be had here.
Best of 73!
Alan...KI6HPO
Hello All,
This mast is going to support the feedpoint of my 204' G5RV.
The
2" bottom mast will slide into an 8', 2 3/8" galvanized fence post,
which is set into 4' of concrete. The spot is on a 25% grade; this
caused me some concern regarding the length of my guy ropes, but I
believe that I've got enough 3/16" Dacron to complete the job.
I
am going to tie the Dacron ropes [to galvanized thimbles and then] to
spikes at four [compass] points on the ground, outside the 33'
diameter circle from the center post. Guy points on the mast will be at
16', 23' and 30'.
I plan on leaving 20"+/- of each spike above ground.
What
is the best way for one person to get the mast as perpendicular to the
ground as possible, while running from "point to point" to last down
the mast while it's teetering?! My wife and I attempted to lash down
this unruly 40 footer in a very light wind on Sunday, with little success!
I'll
be handling 12 long guy ropes, so any assistance from anyone who's done
this alone [or with one's XYL/OM!] would be most welcomed!
Anything I'm forgetting?
Many thanks for taking the time to respond!
Alan...KI6HPO
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|