I've had several. They have presets (holes) drilled for cw and phone
settings. I've cobbled spare insulators and substituted aluminum
rectangular and round tube pieces. DXEngineering makes HD ss clamps and
stuff like that. The boom is two 10-ft pieces of 2" OD 3/16" wall (IIRC).
The loading inductors are expensive to replace (#12 on ceramic, coupling
link on one; I have a long-left-over spare form only), and I've cobbled
those, too. Guess what I'm writing tends to "imo, you don't really need a
book" <grin>.
Good antennas, worked a lot of DX with them.
Went to used CushCraft this time around for no particular reason except it
was there. Used some old leftover Mosley parts in the rebuild. If a whole
used Mosley had been available at that time, it'd be up there now.
73 Dave N3HE
----- Original Message -----
From: "Andre Van Wyk" <kr5dx@yahoo.com>
To: <towertalk@contesting.com>
Sent: Thursday, May 22, 2008 10:02 PM
Subject: [TowerTalk] Mosley S 402 M
>I am looking for a copy of a manual for the Mosley S 402 vintage 40m beam.
>If anyone can help, I will cover all your expenses.
>
> Best 73
> KR5DX
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|