Hello I am looking for some info if possible, I am building a rotor control box
for a light duty rotor I have here , and I am basing my design on a Ham 2
Series of Rotor made By CDE. The questions I have are as follows...
Question #1 What is the full scale defection rating of the meter in a CDE rotor
control box, I.E. 100micro amps
#2 Does anyone know what the output voltage is for the meter
transformer as show in schematics found in the manual? There is no indication
of secondary voltages
shown in the schematic.
The rotor I am using already has a 500 ohm feedback variable resistor inside
it, and I plan to use a circuit similar to that of the Ham 2 series of rotors
so I can have a meter indicator as opposed to 2 silly LEDs that it had before
in the original controller...So its vital for me to find out the answers to my
2 questions above so I can complete my design, I am able to rotate the rotor
with the switches I have incorporated into the control, now I just need to know
where it is pointed ... Hi Hi !!!
Looking forward to any replies I may get both on and or off the reflector...
Regards,
Marc Tessier - VE3TES
http://home.cogeco.ca/~ve3tes
http://www.eqsl.cc/Member.cfm?VE3TES
ve3tes@cogeco.ca
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|