With the dual driven design, the XA is very flat on all
bands. I just looked at my XA on 15 on the swr meter and it
is less than 1.2 across the band, with the traditional
double minimum in the curve.
How are your signal reports? How is the F/B ratio? F/B is
the best way to tell if a yagi is working, and it is easy to
measure:
http://lists.contesting.com/archives//html/Towertalk/2007-06/msg00508.html
Dave Hachadorian, K6LL
Yuma, AZ
----- Original Message -----
From: "mike oconnor" <mike_kn9t@yahoo.com>
To: <towertalk@contesting.com>
Sent: Monday, December 31, 2007 9:30 PM
Subject: [TowerTalk] kt34xa flat swr
>I new there was something wrong with my kt34xa when I had
>trouble with the linear on 15 meters. 20 and 10 meters work
>fine . The swr is as always. But 15 is 1.1 to 1 except at
>band edges where it goes up just a little. Haven't been on
>15 for a long time so don't know when it started. Could it
>be the balun or maybe something just came loose. Never had
>a swr on a beam go completely flat on one band just the
>opposite really high. Any ideas guys? 73 Mike KN9T
>
> ---------------------------------
> Never miss a thing. Make Yahoo your homepage.
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|