...and if it is the well known "Stuck at end of rotation " problem,
once you get it going again, do yourself a favor and buy a
kit from IDIOM Press that allows you to turn the antenna to
a selected Azimuth and has special "Wiggle" mode that is
comes on automatically anytime rotator is at end of rotation
points.
http://www.idiompress.com/rotor-ez.html
I have NO pecuniary interest in the product
73, Dennis N6KI
Sandy Eggo
( Actually SOOTY Diego right now )
On 10/28/07, Barry <w2up3@verizon.net> wrote:
>
> Sounds like sticky brake syndrome. Did you try turning it the other way
> first? If not, hold down the brake and tap the CW button for about 1
> sec. Then, while keeping the brake release pressed, try turning back CCW.
> Barry W2UP
>
> dsteele wrote:
> > I have a new in April Tailtwister. It has had an intermittent problem,
> and finally seems to have died. The rotor would work part of the time, and
> other times it would not move. If you waited a while, it would start working
> fine. Right now it is stuck pointed into the Carribean, whichwon't be good
> for the balance of the CQ WW. I just did all the ohm and voltage tests in
> the manual, and all check normal.
> >
> > Does anyone have any suggestions?
> >
> > Don
> > NT0F
> > _______________________________________________
> > CQ-Contest mailing list
> > CQ-Contest@contesting.com
> > http://lists.contesting.com/mailman/listinfo/cq-contest
> >
> >
> >
>
> --
>
> Barry Kutner, W2UP Newtown, PA
>
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|