I would get the 9405 and parallel the extra #18's with the #16's for the two
motor power wires.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: towertalk-bounces@contesting.com [mailto:towertalk-
> bounces@contesting.com] On Behalf Of Glenn Edson
> Sent: Sunday, May 06, 2007 01:47
> To: towertalk@contesting.com
> Subject: [TowerTalk] Rotator Choice....Yaesu 2800 or Yaesu 1000 ?
>
> We want to thank all who answered our question on the choice of rotators
> for
> our installation. It made the decision easy and the choice is go with the
> Yaesu G-1000DXA. Next question: Any recommendations for rotator control
> cable for a 400ft run from the top of tower to the operating position? The
> rotator only requires a 6 conductor cable but HRO only carries 8 conductor
> cable and their heaviest is Model 9405 which has (6) #18 and (2) # 16
> wires
> and this is their heaviest. Texas Tower carries 6 conductor cable with
> (6)
> #18 wires and advised us this is used with all Yaesu rotators for all
> lengths which is hard to believe. Our concern is with rotation speed
> slowed
> down to a slow creep, which is a problem we had with our last rotator. Are
> there other cables we should consider??
>
> Thanks for everyone's input on this.
>
> Glenn - K1GE
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|