I've been using a prop pitch (with the bevel gear and
associated bearing) for over 35 years. It supports a
mast and antennas that weigh a bit over 200 lbs. I've
never had a problem. It appears that you could go
quite a bit heavier if needed.
73, Stew K3ND
--- Rob Frohne <frohro@wwc.edu> wrote:
> Hi Everyone,
>
> I have been advised by one person that if I use a
> prop pitch rotor, I
> need to make sure I use a thrust bearing, as the
> prop pitch wasn't made
> to support much if any weight. Can anyone give me
> personal experiences
> with/without using a thrust bearing with a prop
> pitch rotor?
>
> Thanks again & 73,
>
> Rob, KL7NA
> --
> Rob Frohne, Ph.D., P.E.
> E.F. Cross School of Engineering
> Walla Walla College
> 100 SW 4th Street
> College Place, WA 99324
> (509) 527-2075
> http://www.wwc.edu/~frohro/
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
>
http://lists.contesting.com/mailman/listinfo/towertalk
>
____________________________________________________________________________________
TV dinner still cooling?
Check out "Tonight's Picks" on Yahoo! TV.
http://tv.yahoo.com/
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|