I never saw any effect from looping the wire back on itself for several
inches. Didn't throw the resonance off a bit. Of course, at 80M a few inches
doesn't make all that much of a difference
Bob//WF3H
----- Original Message -----
From: "John & Peggy" <bankhein@frontiernet.net>
To: <towertalk@contesting.com>
Sent: Saturday, March 04, 2006 3:27 PM
Subject: [TowerTalk] QUESTION ON WIRE ANTENNA TERMINATIONS
>
>
> I wonder if I could get assistance on a wire antenna question? I am using
> #12 insulated wire and when it is terminated at the center and end
> insulators, will the looping through and back around to itself have the
> same
> effect on resonance than if it were a straight piece of wire? I wonder
> how
> much longer or shorter it will effectively add to the length of the
> antenna
> - should I consider the amount being looped or does that cancel out. I'm
> thinking I would prefer to have the strength of the insulation passing
> through the insulator versus stripping back 6 - 8" of the insulation and
> running the bare wire through and soldered back on itself, but if I did
> strip, I am assuming the length would be equivalent to that up to the
> center
> of the insulator hole - correct?
>
> Thank you....John K0JJH
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.375 / Virus Database: 268.1.2/274 - Release Date: 3/3/2006
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|