Towertalk
[Top] [All Lists]

[TowerTalk] Re: [Force 12 Talk] Need info for C4-XL relay box

To: richardcardwell@adelphia.net, towertalk@contesting.com
Subject: [TowerTalk] Re: [Force 12 Talk] Need info for C4-XL relay box
From: KJ6Y@aol.com
Date: Wed, 14 Jul 2004 22:09:09 EDT
List-post: <mailto:towertalk@contesting.com>
Rich,
The relays are 12V DC and you supply your own.  Current draw is minimum.  
Probably less than 1 amp.  Any 18-22 gauge 2 conductor cable should work fine.
When you engage the relay, there are small coils on each side corresponding 
to each half of the antenna.  You're switching those in and out of the circuit. 
 
Adjust the antenna frequency with the coils switched out for phone. Move the 
jumpers on the linear loading wires to do this.  Once that is set switch the 
coils in and you tune them for CW by spreading or compressing the coils 
equally.  I've had some where I had to remove a turn or two to get the 
frequency 
right.
Once set, adjust the matching coil accross the driven element for minimum 
SWR.
Good Luck.


Skip, KJ6Y
Communications Service Co 
_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Re: [Force 12 Talk] Need info for C4-XL relay box, KJ6Y <=