Hi Folks,
It's time to replace the tilt-up cable on the CT-100. There is a bolt
that hold the cable to the side of the drum. Got the bolt loose but it's
longer then there is room for it to exit the threaded hole in the drum.
The head of the bolt runs into the gear reduction unit. Anyone run into
this scenario before?
I'm thinking I can cut the cable and crimp a new one on (don't have the
crimpting tool and not sure I could fit it in close enought the drum) or
could cut the bolt, extract the remaining threaded portion of the bolt
and replace with a shorter bolt...
thoughts,
dave
wa3gin
|