On Mon, 18 Feb 2002 10:51:21 -0500 brewerj@squared.com writes:
>
> I'm planning on installing a guyed 50' Rohn 25 tower, to hold a
> single
> three element tribander. I've gotten the Rohn engineering drawings
> but
> I dont specifically see any plans for an approved base that either
> uses the hinged plate base, or a buried section of tower as the
> base mount.
>
> I do see detail regarding freestanding/unguyed towers, but not
> for guyed. Im specifically looking for hole size and volume
> information.
>
> Is that info available anywhere, for a guyed 50' 25 tower?
Interestingly, I don't see any info in my 1996 catalog for the
hinged base or the buried section of tower for use in guyed
installations.
The drawings for guyed towers all show the pier pin mounting
arrangement, and The CB1 base is specified, which is
2' x 2' x 4' deep, with specified vertical and horizontal
rebar. The drawing # is C610621. Guy anchor details are
on Dwg. C620643.
Dave Hachadorian, K6LL
Yuma, AZ
K6LL@juno.com
________________________________________________________________________
Where do you get ICE bandpass filters & beverage matching boxes? The
same place that pays for the hosting of this list: The eHam Store.
Order online at http://store.eham.net.
-----------------------------------------------------------------------
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|