I'm planning to install a TB3 below the top of the rocket type top
section on my 25G tower. It appears I need to drill four new holes (why
don't they pre=drill these for the TB3?) in the accessory shelf to bolt
it in. Anyone tried this before? I'm envisioning a somewhat critical
process to get the four holes exactly placed, and would appreciate any
helpful hints. My initial thought is to select a drill bit that's one
size larger than the bolt, in case I have trouble with exact placement
using only a hand drill. If there's a simple solution to achieving
acceptable accuracy, I'd sure like to know about it. Please reply to me
directly. Thanks
John K4IQ
jbmitch@vt.edu
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|