Hello All,
Is a 1/4 wave 2M shorted stub the correct bandpass filter to use with the 2M
radio? Of course using a T connector attached to the antenna feed line and
stub.
73,
Ken
KC6TEU
www.qsl.net/kc6teu/
home.earthlink.net/~kmcm
-----Original Message-----
From: rmidgett@edge.net [mailto:rmidgett@edge.net]
Sent: Tuesday, January 12, 1999 8:01 PM
To: Mason, Ken R
Subject: Re: [TowerTalk] 6M & 2M Interaction
Hello Ken,
There are several variables in your situation. In the rover van, we have
had problems with 6m TX getting into 2m RX , & 2m TX getting into 432 RX.
It seems to be a simple third harmonic relationship issue. I have since
traded 6m & 2m radios, so we will see with the new setup in the Jan.
contest.
As a solution, since most of us are limited in terms of what we can put on
the tower, go ahead & assemble your array & see what develops. If you have
some trouble, try putting filters on the rigs to stop the unwanted signals.
There are commercially made items, or you can roll your own.
At 11:06 AM 1/11/99 -0800, you wrote:
>
>Hello Fellow Hams,
>
>I have one tower in which I plan to put 6M, 2M, 432 MHz, 1294 MHz antennas
>on it.
>
>The question I have is what will the 6M interaction be to the 2M antennas
if
>the 6M antenna (5 el. 15' boom) was placed in-between two stacked 2M Yagis
>(13B2 15' boom). The 2M stacked yagis spacing is 10.5 feet.
>
>I have an 8877 amplifier on 6M and another 8877 amp for 2M. If I transmit
on
>6M, should I disconnect the 2M antennas from the radio?
>
>73,
>Ken
>KC6TEU
>www.qsl.net/kc6teu/
>home.earthlink.net/~kmcm
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|