Andrews spec sheets say minimum bending radii are 5 inches and 10 inches
respectively for the cables in question.
73 from
Roger Rehr W3SZ ex-AA3QK ex-WA3JYM
mailto:rrehr@epix.net FN20ah
http://www.epix.net/~rrehr
2 Merrymount Road, Reading, PA 19609
610.670.8687
> -----Original Message-----
> From: owner-towertalk@contesting.com
> [mailto:owner-towertalk@contesting.com]On Behalf Of dan hearn
> Sent: Monday, September 21, 1998 10:20 AM
> To: towertalk@contesting.com
> Subject: [TowerTalk] Heliax
>
>
>
> There are indeed Heliax types w both spiral and non spiral ridges. I
> have owned both and have tried to put the non spiral
> connectors onto the
> spiral stuff. It was several years ago but my recollection is that I
> made it work with considerable difficulty. Seems like the flared clamp
> surface was a bear to fit.I was able to pick up connectors for the
> spiral ridge stuff at the Dallas Hamcom convention.
> On the subject of Heliax, does anyone know the least bending radius
> allowed for LDF 4-50 and LDF 5-50 ? I am faced with a problem in that
> area.
>
>
> --
> FAQ on WWW: http://www.contesting.com/towertalkfaq.html
> Submissions: towertalk@contesting.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: owner-towertalk@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|