My go to guy for Silver-Teflon PL-259 and� Amphenol. Good selection of
Solder and Crimp ON ...Also sells those hard to find heavy duty crimp tools
https://www.ebay.com/str/n5iawrfcommunications
Cant recommend him enough
Dave
NR1DX
On 4/8/2021 3:22 PM, Raymond Benny wrote:
I'm in the process of building a vertical phased antenna system for
80m and
160m. I am looking to purchase some crimp type connectors to build the
phasing lines but have not found any. RF Parts does not have them.
Somewhere online, it was suggested I use the typical RG8 /213 crimp-on
connector instead and wonder if this is OK? I do know that the center
conductor is smaller in diameter than common RG8/213 cable. Would this
make
a difference? It seems to me that in the past I did use the standard PL259
and soldered the center conductor and braid, but I'd rather use crimp-on
type connectors instead.
Any thoughts or other sources for RG11 type PL259 connectors? I did try
google and eBay, but they all ended up showing either RG6 or 'N' type
connectors.
Ray,
N6VR/W7YA
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband
Reflector
--
Dave Manuals@ArtekManuals.com www.ArtekManuals.com
--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|