Hi folks,
I am in need of a Rohn 25 flat top plate or maybe a strong rotor/bearing plate.
I've got to make a custom pulley and smaller return pulley setup for using my
Ramsey worm gear winch to raise and lower a thousand pounds of tower from the
ground up. Running the winch cable up the gin pole, out to a block-n-tackle on
the tower, then back to the other side of the flat top plate is what I have in
mind. I've done it before and it self aligns the tower great as well as
dividing the load in half. My tower weighs just under 1000#'s and so whatever I
come up has to be strong and may well require some welding and drilling. The
top plate doesn't have to be pretty, just work.
Terry
KI7M
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|