Topband
[Top] [All Lists]

Re: Topband: Inverted L successes

To: topband@contesting.com
Subject: Re: Topband: Inverted L successes
From: garyk9gs <garyk9gs@wi.rr.com>
Date: Thu, 31 Aug 2017 16:15:24 -0500
List-post: <mailto:topband@contesting.com>
But being 800+ miles closer to EU (many countries there compared to North 
America) and a path that is largely over salt water is a huge advantage, 
particularly on the low bands.


73-Gary K9GS 
-------- Original message --------From: Carl <km1h@jeremy.qozzy.com> Date: 
8/31/17  3:08 PM  (GMT-06:00) To: GaryK9GS <garyk9gs@wi.rr.com>, 
topband@contesting.com Subject: Re: Topband: Inverted L successes 
Most of LI is glacial sand and only the coastal areas benefit verticals.

Carl


----- Original Message ----- 
From: "GaryK9GS" <garyk9gs@wi.rr.com>
To: <topband@contesting.com>
Sent: Monday, August 28, 2017 8:22 PM
Subject: Re: Topband: Inverted L successes


>
> I suspect that your success is largely due to your location on Long 
> Island.
>
> 73,
> Gary K9GS
> -------- Original message --------From: JAYB1943@OPTONLINE.NET Date: 
> 8/28/17  5:22 PM  (GMT-06:00) To: Doug Ellmore <doug@ellmore.net>, 
> topband@contesting.com Subject: Re: Topband: Inverted L successes
> Last fall I installed an “S-9” 43 ft vertical, added a tapped loading coil
> at the base, with 10 on-the-ground radials about 100 ft long randomly run
> all over my 60x90 house plot. Rig is 300 watts - Started on 160 DXCC with
> 32 entities, finished DXCC in one winter season.
> My secret: JT65 !!!! (tnx K1JT)
> Try anything – you will be amazed how successful you can be on top-band
> with a little patience and VERY modest antennas. 73, Jay NY2NY
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband 


---
This email has been checked for viruses by AVG.
http://www.avg.com

_________________
Topband Reflector Archives - http://www.contesting.com/_topband
<Prev in Thread] Current Thread [Next in Thread>