Im not sure what part this was now ... it seems to be lost to the thread ....
Was it the NXP BLF578XR ? if not has the thought of a HF linear droped because
of harmonics,,,, ECT,??
Mike KC7NOA
> From: w8ji@w8ji.com
> To: w7iuv@yahoo.com; topband@contesting.com
> Date: Sun, 8 Jul 2012 10:18:27 -0400
> Subject: Re: Topband: More Amplifier info
>
> Hi Larry,
>
> All of the links and data agree with what I found here in my measurements. I
> think the real issue is some very creative marketing is being done, and the
> factory data sheets can be a bit confusing. They certainly do not contain
> linear data.
>
> Here are the main points:
>
> 1.) The "1250 watt device" is actually about a 800 watt PEP maximum device
> in linear service. At 800 watts, it is right on the edge of what we are
> accustomed to for Ham product IMD.
>
> 2.) A major problem is heat. Because all heat is in one small footprint, it
> needs a very thick machined copper spreader or liquid cooling, even at just
> 800 watts PEP.
>
> 3.) Like any other device, they will fail with mismatch at high power. They
> absolutely will require SWR shutdown and temperature monitoring.
>
> If we read all of the links carefully enough to cut through the marketing
> fluff, we will see every reference link listed (where they have actually
> tested) agrees with all of this.
>
> I think what has really happened, is many home or first-time builders have
> taken the data sheet at face value. They have convinced themselves this is a
> 1250 watt output device that can be run right into almost any load without
> worry. Of course, neither of those things are remotely true.
>
> I understand it is tough to let go of the magic of a single 1250-watt device
> that slapped on a heatsink without protection, and can be run into a 65:1
> SWR without failing. But this is really a 800 watt PEP linear device that
> comes with all the long term baggage of any other similar device, as ALL of
> those links also seem to agree with.
>
> At 600 watts it will be pretty clean. At 800 watts about at the lower limit
> of what cheap tube amps can do. All of this requiring getting the heat out,
> and shutting it off if SWR goes high.
>
> 73 Tom
>
> <<<<<Like Tom, I am convinced that it is not possible to run that part at
> full power in normal amateur service due to the heat issues. Maybe some
> energetic person will build one up for 1.8 MHz using cryogenic cooling and
> let us know how that works out...
>
> 73,
>
> Larry - W7IUV>>>>
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|