Ive built them in both plastic Hammond boxes and PVC pipe with caps.
Both have survived up to 30 years in NH weather. The ones I took apart last
year when I went to binocular cores and 2 wire Beverages were completely dry
with no sign of ever being wet.
Of course the pipe cap version had to be cut open.
Carl
KM1H
----- Original Message -----
From: "Dave Mueller" <daven2nl@gmail.com>
To: <topband@contesting.com>
Sent: Friday, November 11, 2011 4:42 AM
Subject: Re: Topband: Beverage transformer enclosures
> On 11/11/2011 9:11 AM, Paul DeWitte wrote:
>> What do you use for transformer enclosures?
>>
>> The ones that I have been using did not stand up. Just curious what
>> others
>> use.
>>
>>
>
> Here on Guam, we get more than 90 inches of rain annually. I have found
> that it is impossible to keep water out of enclosures, and if drain
> holes are drilled into the bottom, ants and other jungle critters will
> move in with dirt, ETC, that cause the same problems as a flooded box.
>
> For me, what works best for my simple transformers (nothing requiring
> power) is to use a small Radio Shack or similar plastic enclosure with
> the lid off. The enclosure serves to mechanically hold and protect the
> transformer in place. I do seal the underside of the RG6 bulkhead
> connector with RTV sealant to protect against moisture ingression into
> the coax. The whole thing is covered with a cut-off water bottle to
> keep direct rain off the transformer.
>
> This idea may not sit well with perfectionists, however it works fine
> for my purpose.
>
> 73, Dave KH2/N2NL
>
>
>
>
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1411 / Virus Database: 2092/4010 - Release Date: 11/11/11
>
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|