Charles,
I also use the same choke construction as Tod, K0TO.
Six turns through 5 Fair Rite No. 31, 2.4" dia ferrite cores.
Works very well, essentially zero loss and no heating issues.
Note, put the Pl-259 on after you make the choke coil or you
will be able to only get about 4 turns !
73,
Bob
K6UJ
On Mar 6, 2011, at 9:32 PM, Milt -- N5IA wrote:
> And I make all of my choke baluns for 160 Meter energy from 30 turns, 6" in
> diameter, of whatever cable it is. This is coaxial leads as well as rotor
> cables, etc. Works like a champ.
>
> Milt, N5IA
>
>
> -----Original Message-----
> From: Tod - ID
> Sent: Sunday, March 06, 2011 2:15 PM
> To: 'Charles Moizeau' ; 'Topband'
> Subject: Re: Topband: Preferred Choke Baluns
>
> Charles:
>
> I make 160 meter RF Chokes [Choke Baluns] by running six turns of coax
> through 5 cores of Fair Rite type 31 [2.4 in diameter cores]. Five turns and
> six cores will also work.
>
>
> Tod, K0TO
>
>
>
> -----Original Message-----
> From: topband-bounces@contesting.com [mailto:topband-bounces@contesting.com]
> On Behalf Of Charles Moizeau
> Sent: Friday, March 04, 2011 9:52 AM
> To: Topband
> Subject: Topband: Preferred Choke Baluns
>
>
> I'd be grateful to learn the preferences of users of these devices.
>
> My set-up is 50-Ohm, 0.405" diameter (Wireman X-4XL) coaxial cable,
> underground, but within electrical pvc conduit. This attaches through a
> PL-259 to a DX Engineering radial attachment plate. The antenna is an
> inverted L with its base fed just through a variable capacitor (set for my
> antenna at ~ 255 pF) .
>
> I have given thought to chopping the PL-259, stringing a bunch of Palomar's
> ferrite beads on the coax and then re-attaching the PL-259.
>
> However, an alternative would be to insert a manufactured or home-brewed
> balun, toroidal or solenoidal, between the radial attachment plate's SO-239
> connector and the variable capacitor.
>
> Physical space is not a problem because I've discovered that the DXE radial
> attachment plate will fit nicely into a 12" x 12" x 6" heavy-duty gray pvc
> electrical box ($33 at Lowes). I plan to revise the existing and quite
> messy above-ground set-up so that the radials will be inserted into the box
> through tight-fitting and caulked notched holes in the four top edges, just
> below where its cover will fasten, with their solder lugs attached to the
> plate 180 degrees opposite from the conventional configuration. In this way
> the whole business can be buttoned up tightly and buried, with just the
> antenna's attachment point and the capacitor's adjustment shaft sticking up.
> Perhaps this plan will be inspirational to others.
>
> I'd prefer to see any choke balun recommendations posted to this list rather
> than sent directly, so as to share the "wealth".
>
> Tnx es 73,
>
> Charles, W2SH
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1204 / Virus Database: 1435/3486 - Release Date: 03/06/11
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|