Hi,
Few weeks ago I installed an EWE as Rx antenna.
The EWE is 10 ft high & 41 ft long.
The EWE it´s over a concrete base and both ends are connected to a common
ground.
The swr at 1.830 is 1.5
a Pre-Amp it´s being used at the mast.
I beamed to the North, at least I think so, installing the feed point at the
North and the resistor at the south.
I got surprised when I found that the most QRM heared at my shunt-feed tower
was audible as BC stations. so I imagine that the antenna is working?
The problem that I found was at DX level, because most NA stations are heared
at least the same as with the tower or worst.
What I am doing wrong?
Thanks in Advance,
Javier / yv5mbx
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|