TenTec Omni VII Transceiver, Filter,
Microphone, Parts, and more For Sale:
.
TenTec Omni VII/AT High End HF Transceiver:
FEATURES:
Transmit coverage on 6-160 meters, 100 watts out,
...even on 6
General coverage receive from 500 kHz to 30 MHz
...continuous plus 48 to 54 MHz
SSB, CW, AM, FM, Digital modes
Dual VFOs with SPLIT and REVERSE
Full function Color Screen
Legendary QSK CW. Built in keyer
17 selectable transmit bandwidths
37 receive DSP filters - 200 Hz to 9 kHz
DSP Noise Reduction
Band Sweep
Quad bandstacking registers and 100 memories
Unrivaled Close in Dynamic Range
Three built in filters at 20 kHz, 6 kHz, and 2.5 kHz
2.5 kHz is a Collins mechanical filter
Optional Auto Antenna Tuner w/100 Tune Memories
Three antenna connectors
Updates by Flash ROM
Serial port interface for local rig control
5 H x 12 W x 14.75 inches D.
This one looks like new and works the same.
Optional antenna tuner, power cord, and paper work
for $900.
.
Crystal Filter for TenTec Rigs:
This filter is used in TenTec rigs
in the 9 MHz IF. This includes the Orion I,
as well as Omni series A, B, and C; Omni V,
Omni VI, Argosy, Paragon, and maybe others.
.
InRad 762 premium filter
600 Hz wide, CW, $125
.
TenTec Hand Microphone:
This mic is similar to the TenTec model
700, although I do not find that number
on it. It is black plastic case, with
PTT switch. It is an electret mic, with
great frequency response, and a 4 pin
mic plug. $30
.
XLR Cables
All of these cables have a very nice rubber
covered cord, with a 3 pin female XLR
connector on one end.
About 8 feet long, with male 3 pin XLR
connector on other end (extension
cable) $28
20 feet long, extension cable (as above),
still in package, new. $35
About 25 feet long, extension cable (as
above), $35
About 8 feet long, with 1/4 inch mono plug
on the other end. $25
About 8 feet long, with nothing on the
other end. $20
.
Female 3 pin XLR to 1/4 inch plug. $10
.
TenTec Omni 546 Parts:
I have a TenTec Omni D, Series B, Model 546 that I
am parting out.
Many, probably most, of the parts are compatible
with most all of the Omni series A, B, and C rigs.
PTO, digital readout, both covers, front panel, and
final module are gone, but many, many parts are still
available.
Available:
Metal parts:
Rear panel
left and right sides
main chassis
3 switch module on left side
S meter light and socket
Plastic PCB Holder sockets
Offset pot
Drive pot
Selectivity rotary switch
Mode switch
Mic jack
Headphone Jack
Plus a few things not listed.
Please let me know what you need.
.
TenTec Century 21, Model 570 Parts:
I have parts from a Century 21, model 570, available.
Most of these parts should also fit the Model 574
digital version.
Hopefully these parts will let several rigs live again.
All covers, PTO, knobs, power supply parts, and final
module are gone.
Available Parts:
Metal parts:
Inside front subpanel
Rear Panel
Both left and right sides
Main chassis
Headphone Jack
3 pilot bulbs and sockets
Circuit Board Assemblies Available:
Audio Power Amp 80357
Front end board 80359
Low Pass Filter 80360
Please let me know what you would like.
.
I also have many other accessories available
such as many different types of microphones,
HTs, VHF and UHF rigs, HF and VHF/UHF antennas,
connectors, miscellaneous accessories, etc.
Just too many to list here.
Please e-mail your requests.
.
Prices do not include shipping from Florida.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK@FLHam.net or W8EK@arrl.net
Voice Phone (352) 732-8400
.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|