Peter -
You can change the baud rate in Windows Device manager (under properties
for the com port you are using).
I too get the cyclic sound, which I've traced to the RS232 board. Thought
it was me, but happy(?) to see someone else is experiencing the same
problem.
One question though: How to change the address to 2C? My experience is
that there is no alpha characters on the Paragon II (although I have seen
this in other models like the Omni 6, 6+). I currently set the model to
an IC 765 in N1MM as described in the manual.
If there is a better model to use in N1MM, please let me know.
At the moment, I set it to 04 on the paragon and change it in N1MM to
match. N1MM complains about it (only on startup of N1MM) but runs.
73
Mike, K1SLT
--
mgolini@gmail.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|