Releasing PL14 should give you the movement you require Terry but would
suggest for peace of mind to take the board out completely and to do
this jobe and make sure it is well tethered with replacement screws when
finished. GL
Malcolm F5VBU
On 3/7/2020 2:21 AM, Terry Berman wrote:
I need to attach a new coax cable between the PA and the LPF board. To do
this I need to get to the underside of the PA board. I've loosened all
the screws on the PA board to see if it would nudge up a little but it
seems very firmly attached. I want to avoid causing damage. Anyone done
this before and have some pointers?
Thanks,
Terry Ki3C
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|