Thank you for these instructions. How do you turn off Mtune?
Robert
KG4KGL
> On Jun 15, 2016, at 17:17, Carl Moreschi <n4py3@earthlink.net> wrote:
>
> There's a software procedure in my Omni V.9 firmware that allows you to
> exactly calibrate it.
>
> Here's a clip form the Omni V.9 manual that tells how to do it.
>
>> Crystal Calibration Mode -
>>
>> There is now a way to correct for crystal aging. To calibrate
>> a specific band, proceed as follows:
>>
>> 1) Tune to the band and frequency of the known source signal.
>> Mtune must be off for this procedure.
>> 2) Tune the dial to read the exact frequency desired.
>> 3) Press SHIFT TUNE.
>> 4) Tune the signal in as accurately as possible. The display
>> should not change while you are tuning. Take care to not
>> tune the dial any more than is necessary.
>> 5) When the signal is properly tuned, Press ENTER. This will
>> exit the crystal calibrate procedure.
>>
>> Please note that the scratch pad memory and alternate VFO will be
>> set to the value of the current VFO when the procedure is complete.
>
>
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
>> On 6/15/2016 4:34 PM, Dry Martini Holding Company😎 wrote:
>>
>> I have an Omni V with the N4PY V.9 upgrade. A problem has recently surfaced.
>> On 40m for instance, when I am talking to someone on say 7115khz, I have to
>> tune the rig to 7114.2. IOW, my freq display is reading lower than actual.
>>
>> On 20m I had a QSO on 14056, but my display shows 14057.
>>
>> What. Involved in calibrating the freq display?
>>
>> Tnx,
>>
>> Robert
>> KG4KGL
>>
>>
>> Sent from my iPhone
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|