Barry and friends
i repaired the Corsair II in effect the problem was a ca3053
Thanks to the Ten Tec Enginners had put in the PCB the holes for a 8 pin
IC.
The corsair Is in the Air Again.
Thanks for all suggestions.
gus
lw3ewz
-----Mensaje original-----
De: TenTec [mailto:tentec-bounces@contesting.com] En nombre de Barry N1EU
Enviado el: sábado, 13 de septiembre de 2014 7:07
Para: Discussion of Ten-Tec Equipment
Asunto: Re: [TenTec] Ten Tec Corsair II buzz in ssb
Gus, there are plenty of eBay listings for CA3053 chips.
73, Barry N1EU
On Sat, Sep 13, 2014 at 3:51 AM, Gustavo Andrada <lw3ewz@speedy.com.ar>
wrote:
> Stuart
>
> im almost shure the problem is in ca3053 because use the solder in the
> conection of pin 1 balanced modulator in...
>
> tomorrow try for one in bs. as.
>
> i need lucky for accquire this IC.
>
> 73
> gus
> lw3ewz
>
> -----Mensaje original-----
> De: TenTec [mailto:tentec-bounces@contesting.com] En nombre de Stuart
> Rohre Enviado el: viernes, 12 de septiembre de 2014 22:21
> Para: Discussion of Ten-Tec Equipment
> Asunto: Re: [TenTec] Ten Tec Corsair II buzz in ssb
>
> Good Luck Gus with the troubleshooting. The other replies are all
> good ideas as well.
> 73,
> Stuart
> K5KVH
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|