| To: | <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Omni C parts |
| From: | "Paul DeWitte" <k9ot@yousq.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 13 Feb 2014 11:30:13 -0600 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I am looking for a board # 80708 control board for my 546 Omni C. Anyone out there with a parted out rig with with an 80708 board? Thanks,73 Paul _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Anyone using LP-PAN with Orion/RX366?, Barry N1EU |
|---|---|
| Next by Date: | [TenTec] Anyone using LP-PAN with Orion/RX366?, Floyd Sense |
| Previous by Thread: | [TenTec] Anyone using LP-PAN with Orion/RX366?, Barry N1EU |
| Next by Thread: | [TenTec] Anyone using LP-PAN with Orion/RX366?, Floyd Sense |
| Indexes: | [Date] [Thread] [Top] [All Lists] |