Hello Gus,
It may be a case of filter mismatch, both Z and frequency. Ten-Tec filters
are 200 ohm Z and 9.0015Mhz center frequency. In lock position the carrier
may be outside the passband of your KVG filter resulting in no output.
Also, the drive control must be turned clockwise to produce output power.
73,
-Lee-
WA3FIY
On 21 Sep 2013 at 19:06, lw3ewz wrote:
> Dears Members
>
>
>
> I put in my corsair II a KVG Cristal Filter 3.6 khz 9 Mhz z 1000 ohms
> after the conect the filter the corsair receive perfect with excelent audio
> (extra bass), but not power out in TX . putt he lock position and drive
> fully counterclockwise but no power.
>
>
>
> I request a Barry n1eu for this problema too.
>
>
>
> Any idea.. before conect original filter. Any adjust is necesary.
>
>
>
> Thans in advance
>
>
>
> 73
>
> Lw3ewz
>
> Gus Andrada
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|