TenTec
[Top] [All Lists]

[TenTec] Omni VI+ Frequency Display Problem Only On LSB

To: <TenTec@contesting.com>
Subject: [TenTec] Omni VI+ Frequency Display Problem Only On LSB
From: "Tom Stone" <sail8@verizon.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 09 Jun 2011 21:59:30 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Has any owner of an Omni VI+ ever had a problem similar to this? (With the
RIT off, Identical Side tone and Pass Band Tuning set at zero on both rigs)

 

Switching between my Orion II and Omni VI+ using an Alpha Delta switch on
the same antenna. The Omni was just serviced by Ten Tec.

 

160M - LSB - Orion II 1.900.000 For the same voice quality (sounds the same)
the Omni had to be tuned to 1.899.75

 

80M - LSB - Orion II  3.868.000 For the same voice quality (sounds the same)
the Omni had to be tuned to 3.867.75

 

Question: What could account for the consistent .25 difference in the
frequency read out?        There is no difference when I am in the USB mode.

 

Would appreciate any available input.

 

73,   Tom  N3XQ   

 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>