Use at least 3 digits when you set RIT. Use *RMR050Cr for 50 hertz of RIT.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 6/3/2011 3:10 PM, Barry N1EU wrote:
> For those of you who have worked with programming Orion macros, I'd
> appreciate some help. I want to use a macro to set an RIT value or to
> clear the RIT. I've got *RMR0<cr> successfully clearing RIT but I
> can't get *RMR50<cr> to set a 50hz RIT value. Is there some trick I'm
> missing to get RIT set?
>
> Thanks& 73,
> Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|