TenTec
[Top] [All Lists]

Re: [TenTec] how do I ?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] how do I ?
From: John Molenda <cdistflatfoot@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 06 May 2011 15:02:42 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On 5/6/2011 2:44 PM, Carl Moreschi wrote:
> My N4PY software will allow quite a bit of out of band transmission.
> This is mainly for tranverter use.
>
> Carl Moreschi N4PY
> 121 Little Bell Dr.
> Hays, NC 28635
> www.n4py.com
>
> On 5/6/2011 2:29 PM, John Molenda wrote:
>> Hi Gang , I would like to get my orion II to transmit out of band so
>> that I can get my palstar autotuner to tune there about 10 watts would
>> be all that is needed .  I find it helpful  when I go on listening
>> expeditions .  thanks John
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
Thanks Carl
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>