Thanks for all the tips. If cleamging does not work I am wondering if i could
"touch" up the solder by heating the pins from the exposed side with out
damaging the plastic. Probably not a good idea but that board looks like a
bear to get out.
-----Original Message-----
From: David Goncalves <davegoncalves@gmail.com>
Sent: Thursday, April 01, 2010 5:12 PM
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni A-D Series B Con't
Had the same problem with my Omni-D. Do clean the crystal pins and sockets
first.
Sockets can be cleaned with a toothpick moistened with DeOxit.
Is that don't completely fix it, you can tighten up the crystal sockets by
using a toothpick (again!) to try and squeeze the two sides of the socket
cup tighter.
Removing that board should be your LAST resort.
David Goncalves
On Thu, Apr 1, 2010 at 5:03 PM, Louis Ciotti <lciotti1@gmail.com> wrote:
> So I took to cover off ans was poking around. I found that if I bush
> down on the crystal socket, the non-working bands come alive. So at
> this point I am assuming a bad solder joint at or near that point.
> Now I just have to get brave enough to get that board out. It has
> some of the band switches on it and am wondering how to get that
> "chain" off so I can remove the board to get at the bottom side.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
--
David Goncalves
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|