haney
Check the audio stages and work back.
Might have a bad coupling resistor.
Ron
K3MIY
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Howell, D. Haney
Sent: Monday, September 28, 2009 3:15 PM
To: tentec@contesting.com
Subject: [TenTec] Omni 5 Feedback
My trusty Omni 5 has been under wraps for a few months. When I fired it up
recently I experienced motorboating and rumbling feedback though the
speaker. As the old hamfest saw goes, it was working fine the last time I
used it! Any suggestions where to start troubleshooting?
Haney
k2xn
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|