Ron,
Thank you for your help. I have not received the rig yet, hopefully
tomorrow. The manual should have the pin out for the mic, at least I hope
so.
Best,
DW Holtman
WB7SSN
----- Original Message -----
From: "Ron Zond" <k3miy@csonline.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, January 06, 2009 6:21 PM
Subject: Re: [TenTec] TT 705 Mic
> DW
>
> The 705 does not need the battery; it gets its power from the rig.
>
> Ron
> K3MIY
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Don Steele
> Sent: Tuesday, January 06, 2009 7:27 PM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] TT 705 Mic
>
>
> DW, The 705 should be wired to plug directly into the Omni 6. It uses the
> pre amp and should obtaing its power from the rig.
>
> Don
> NT0F
>
> ----- Original Message -----
> From: "DW Holtman" <tubestuff@comcast.net>
> To: <n2wjw@yahoo.com>; "Discussion of Ten-Tec Equipment"
> <tentec@contesting.com>
> Sent: Tuesday, January 06, 2009 5:52 PM
> Subject: [TenTec] TT 705 Mic
>
>
>> Hello,
>>
>> I just aquired a Omni VI Plus and from a different source, I have a 705
>> mic.
>> I'm not familiar with thie mic. It has a circuit board (pre-Amp) built
>> in.
>> My question, should I use the pre-amp or bypass it and connect the output
>> directly to the Omni VI?
>>
>> Thank you in advance for any advice.
>>
>> Best,
>> DW Holtman
>> WB7SSN
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|