After posting this question I went back and
touched the ball bearings with the razor and
they all came out. I guess the grease lighting
finally soaked in and loosened the grease.
73 back to the rebuild.
Wally
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of w1ioo@cooledge.com
Sent: Saturday, September 06, 2008 2:34 PM
To: tentec@contesting.com
Subject: [TenTec] Rebuild 509 PTO
I have the rebuild kit from TenTec. Following the directions everything was
going fine till I had to remove the ball bearings. They won't come out. I
have tried alcohol and Grease Lighting. This product seems to melt the
grease. No luck. They just seem to be stuck in the brass. I was thinking of
a little heat from a soldering iron might loosen them. Would like some ideas
before I destroy it. Thanks in advance.
Wally w1ioo
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|