I, too, have replaced simple parts (after failures of T T replacements/repairs)
on my Ten Tec gear with my own higher quality ones and
had no failures afterwards.
Charles Harpole
k4vud@hotmail.com
> From: ronc@sonic.net
> To: tentec@contesting.com
> Date: Tue, 24 Jun 2008 22:19:27 -0700
> Subject: [TenTec] Orion II A9 Board Failure...Again!
>
> About 10 months ago, the capacitors on the A9 Power Distribution board
> failed, and I sent the radio back to the factory to get it fixed. Well, just
> 10 months later, the same thing happened again. This time, I decided to fix
> it myself with premium capacitors purchased through Mouser. The fix worked!
> The 470 uf, 16 Volt, 85 degree C caps, C6, C7 and C9 were replaced with
> ultra-low ESR 50 Volt, 105 degree C units that fit perfectly in the board.
>
> I have a whole page on my website for anyone interested, including pictures
> and ordering information for the caps. Hopefully, these will last longer than
> the first two sets!
>
> http://n6ie.com/A9_Board.mht
>
> Ron N6IE
> www.N6IE.com
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|