If you're referring to the 961 power supply as a Corsair II supply, you're OK.
I use it on the Corsair II, Paragon and Omni VI+. It's rated at 20 Amps, has an
over-current sensor set for 22 amps and has over-voltage protection set to 16
volts. Additionally, I believe that the Paragon II does have some internal
protection for high SWR's.
If you don't have them, it is always a good idea to call TenTec and order
manuals for each piece of gear that you have. Read them to know what it can do.
Then play with the settings. Of all the brands that I have owned, only Heathkit
has ever produced as good a manual as TenTec. They're the best.
73
Dave
WA3MKB
-------------- Original message --------------
From: OTAKEBI@aol.com
> The problem in using a Corsair II supply is that I think it only supplies 18
> amps.
> I may be wrong but I think the OMNI V, VI, and Paragons use the 20 amp
> supply.
> The Corsair II supply will work as a protection breaker but the supply won't
> give full output on the Paragon.
> I may be wrong on that and if so you guys let me have it if I am.
> Dan/N4VET
>
>
>
> ************************************** See what's new at http://www.aol.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|