Bob,
I don't have nor have ever owned an Omni V. But as a shot in the dark, try
reheating the connection pins for the encoder. I have an Orion I and have
had trouble twice with the encoder for the RIT/XIT. Both times it cured the
problem. With the Orion, pressing the encoder resets things to "0". I look
at it as an easy "try" before totally replacing the encoder. Good luck.
73,
John
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Bob Towers
Sent: Tuesday, July 31, 2007 10:03 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Frozen display on Omni V.9
Bob McGraw - K4TAX wrote:
> Could this be one of those "3rd party" software glitches?
>
> A full reset may correct the issue or maybe return to the original Tentec
> issued software which did not encounter the concern.
>
> 73
> Bob, K4TAX
>
>Thanks, Bob, for your suggestions. The full reset didn't do the trick,
by the way.
I'm not sure about the software. The V -> V.9 mod involves replacement
of the main EPROM ie a change of the firmware. There are enough V.9
modded rigs out there to have shown up this problem already, if that had
been the cause.
73
Bob
MM0RKT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|