Hi,
I have a Titan 425 and haven't had any issues with the QSK keying.
I have both the keying loops enabled and the weighting set to 8ms.
I did the logic board mod and have been happy with the sweep as well.
My mic gain did need to be turned down quite a bit and I have noticed some
crackling in the monitor audio on voice peaks if it is left too high.
I'm not much of a speech processor user but it seems to have a little too
much "attack" even at a setting of 1. Not a show stopper for me but it is a
nit...
The increased monitor audio is a plus for me as well.
Overall I'm happy with 2.054 and consider it pretty solid.
73,
George / KF9YR
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Message-ID: <000c01c63821$5d9b68a0$6401a8c0@TOBYROOM>
Content-Type: text/plain; charset="iso-8859-1"
Hank, I have a Centurion AMP and had trouble using the keying loop. On cw
using the keying loop in the QSK mode on the amp, the cw keyed just fine.
But when I went to turn the rig off, and then turn it back on the rig would
not boot up. All the lights on the front panel would light up including the
TX led and the screen was blank.
Nothing I could do would bring the rig back on line. I finally powereed up
and held the USER 2 button as I powered up and then the rig went into the
flash update mode. I then had to reload the firmware. Be careful using the
keying loop with a Ten Tec
QSK amp. It would be best to use the PTT keying line and leave the keying
loop alone for now.
Toby W4CAK
----- Original Message -----
From: "Henry Pfizenmayer" <pfizenmayer@worldnet.att.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, February 22, 2006 9:01 PM
Subject: Re: [TenTec] Ver 2.054 update - comments
> Anybody out there using 2.054 with a Centurion or other TT qsk amp ?
>
> And the original 565 O ?
>
> Just got my 565 O back today with latest mods and ver 2.054 Feb 10 ,
2006
> firmware . It seems the EXT TR delay is not working anymore on CW /QSK -
> seems to work with variable delays on PTT/VOX .
>
> I always operated QSK with the default 20 percent delay which kept the TR
> relays from following every dit but open between words or pauses which
> worked fine at my speeds . But now the delay adjustment has no effect at
all
> in QSK , the relays follow every dit . Yes I have double and triple
checked
> the TX EN / KEY OUT and TX OUT /KEY IN cables .
>
> 73 - Hank K7HP
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
------------------------------
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
End of TenTec Digest, Vol 38, Issue 103
***************************************
_________________________________________________________________
On the road to retirement? Check out MSN Life Events for advice on how to
get there! http://lifeevents.msn.com/category.aspx?cid=Retirement
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|